The provided VRECORD.USR has the following content:
; VRECORD.USR User Profile which controls calls to record voice files
; ===================================================================
; Specify the location of infobox files for this application:
$script_locn VR VRZ @FFBASE\SAMPLES\VRECORD ; VR*.IIF are in the VRECORD folder
; Specify the location where recorded files are to be placed:
$rcrd_dir @FFBASE\SAMPLES\VRECORD\FILES ; messages go in FILES subfolder
; Specify the file to maintain the recording file-number. This file must exist
; and contain a numeric value on a single line. The value is double-expanded.
$var_def RECNEXTFILE @FFBASE\SAMPLES\VRECORD\NEXTMSG
; Specify recording format. You must check (in ref manual appendix K) that the
; format is supported by the board/port used for this application:
$var_def RECFORMAT WAVPCM8 ; set format to be used as RECORDING_FORMAT
; Other necessary parameters:
$vmsg_dir @FFBASE\stdvoice ; define in case any error messages are needed
$set_state GOOD_BYE s:HANG_UP ; suppress GOOD_BYE message
$retry_max 0 ; no need to retry failures
The following content is required:
| $script_locn | This command must locate infobox commands with names starting VR and should normally point to the supplied samples folder. Note that if the application infoboxes are updated at a future date, new examples will be placed in the SCRIPTS folder so that any custom changes are not overwritten. |
| $rcrd_dir | This command will specify the place where recorded files are to be written. |
| RECNEXTFILE | This variable specifies the pathname of the file containing the next message-file number, which will be updated as each recording is made. The text file specified in this variable is a required file. It must be present to use this application. |
| RECFORMAT | This variable specifies the format of the output WAV file. It must be one of those described in Appendix K as supported by the board used to make the recording. |
