Override DTMF Timeout Period to Assume Touch-tone Entry is Complete
This command is specifies the timeout period after which is assumed that caller DTMF entry is complete. The value is normally only used when at least one DTMF digit has been keyed in response to a prompt; before any entry is detected the timeout specified by $repeat_msg applies. This command overrides the $tone_wait command in the configuration file or user profile, if any. The setting made by this command applies for the remainder of the call unless again overridden.
The parameter on this command is used as follows:
|seconds||timeout period after which DTMF entry is considered complete.|
If the caller presses the # key to complete an entry, the timeout period is not used. For a prompt where it is valid to have no input, the $tone_wait period determines how long the user has to make an entry, not the $repeat_msg period.
Default: the value from configuration file or user profile, or 3 seconds if no other entries